*** file readme.txt *** last change: 12:27 1999-03-15 *** Update instructions for the CAMAT software: !!! *************************** CAUTION **************************** !!! !!! !!! !!! By updating your CAMAT software, you will loose >>> ALL <<< !!! !!! previously saved information e.g.: !!! !!! user defined programs, !!! !!! calibration, !!! !!! selected language. !!! !!! !!! !!! After the update, the camera will be in a "FACTORY-CLEAN" state. !!! !!! !!! !!! **************************************************************** !!! This archive contains the following files: 1. caxxx11x.msf - the CAMAT software version 1.1.x (x: current release) 2. readme.txt - this file To use the CAMAT sofware, a licence file is necessary. It is supplied by your CAMAT dealer and is named according to the serial number of your camera: 51yyyyy.msf - licence file (51yyyyy: serial number of camera) or 65yyyyy.msf - licence file (65yyyyy: serial number of camera) To update the CAMAT software proceed as follows: 1. Connect the camera to a PC using a RS232 serial cable. 2. Start a terminal program on the PC (procomm, telix, etc.). 3. Set the terminal parameters of the chosen port to 9.600 baud, 8 data bits, 1 stop bit, no parity. 4. While holding down the "Esc"-key on the PC, reboot the camera. 5. After some boot messages, a camera prompt '$' should be seen on the terminal. If not repeat from step 4. 6. Press the on the PC several times. 7. Type in "er". The flash-EEPROM will be erased. 8. Type in "lo". 9. Initiate the "upload ASCII file"-mechanism on the terminal and select file "caxxx11x.msf". Uploading will take 30-60 min. 10. If the message "S-record load succesful" appears, repeat steps 8 and 9 with the file "51yyyyy.msf" or "65yyyyy.msf". This will take several seconds. 11. If the message "S-record load succesful" appears again, you are done. Connect the camera to the keypad and the video monitor and reboot the camera: the system is ready for programming.